Non-motorized traffic lights installed to note:

1, non-motorized traffic lights installation height in the general case, 2.5 ~ 3 meters, if in the use of motor vehicle lamp light pole adopts cantilever installation of non-motor vehicles light cases, installation height is the same as the motor vehicle lights.

2, non-motor vehicle driveways light bearing installation, should make the yellow signal light axis pointing to the front horizontal distances between anode and lamps and lanterns is 25 m, the lamps and lanterns of the non-motor vehicle lanes controlled by center distance road surface height is 1.6 m.

3, under the overpass non-motorized traffic lights installed on the bridge, overpass the other side should add a signal chy-tech non-motor vehicles.

4, turn left at the don't need a separate control of motor vehicle traffic flow, vertical installation of traffic signal lamp color sequence by down, the order should be red, yellow and green.

5, when a motor vehicle you with the distance to the motor vehicle traffic lights more than 50 m, should be to install a new import a non-motor vehicle headlamp unit signal, can be installed at the inlet, 0.8 ~ 2 m before you place the distance away from the curb on the right side is 0.8 ~ 2 m of pavement or non-motor vehicle lane on the left side of the machine within the barrier.

6, in the absence of motor vehicles and non-motor vehicle domestic road barriers, non-motorized traffic lights set appropriate USES attached type installation, installed on the guide of motor vehicle traffic signal lamp post.

本文章由交通信號燈廠家供應(yīng)